Juniper JNCIA Certification Exam JN0-561

After some reoccurring trouble with paper jams on a laser printer with multiple
trays you order and install a maintenance kit.JN0-560 In order to verify that the problem is
resolved, what should you do?

A. Print a test page from all paper trays.
B. Use the printserver to send a calibration page to the printer.
C. Reset the printer's memory and configure JN0-561 the separate trays from scratch.
D. Throw away the paper that is in the trays and reload the trays with paper that is
verified to be of the correct thickness.

Answer: A

Cisco Wireless LAN Certification Exam 642-587

You are working as a technician at certifyme.com. You have been asked to
troubleshoot a problem where none of 3 SCSI drives in a chain are seen. To
troubleshoot this problem, you should start with checking:

A. for SCSI-2 host adapter ID 7 or 15 and whether all the hard drives are terminated and
have a consecutive ID of 0, 1 and 2.310-200
B.
Leading the way in IT testing and certification tools, www.certifyme.com
- 22 -


for SCSI host adapter ID 0; whether the chain is terminated and that all hard disks share
the same ID.642-503
C. for the SCSI-2 host adapter ID 7 or 15 and whether both ends of the chain are
terminated and that every hard drives has a unique ID.
D. whether the host adapter is terminated and has a unique ID and that the 3 hard drives
have a consecutive ID of 1, 2 and 3.

Answer: C
Explanation: All devices on a parallel SCSI bus must have a SCSI ID.642-587 The initiator
(adapter or controller) SCSI ID is usually set by a physical jumper or switch. The
target (disk-drive) SCSI IDs are either set by physical jumpers or by control signals
which vary for each connector on an enclosure backplane.